Ultraflex 43513Z, Installation And Maintenance Manual

Page: 9 / 48

TIE BAR A97
-
page 9
of 47
Installation and Maintenance Manual
ENGLISH
ULTRAFLEX
2 INSTALLATION
2.1 Necessary tools
2.2 A97 Installation
1 Install the cylinders on the external motors by carrying
out the instructions indicated in the manual.
NOTE
The operations described in point 3 PRE-ASSEMBLY
INSTALLATION can be carried out before installing the
cylinders on the engines.
22 mm hexagon wrench
Dynamometric wrench
Cross slot screwdriver
Loctite® 270
2x
4mm hex key
10-14-16 mm hexagon wrenches
2 BRACKET INSTALLATION A
With the Mercury Engines listed at page 8, it is necessary to assemble the bracket (1) on the central engine
arm by positioning the screws 5/16 UNF (2) and by putting the washers (3) between the bracket and the
screws. (All these elements are included in the bag E). Tighten to the torque indicated by the motor mechanic.
NOTE
Position the bracket with the spot-facing of the hole upwards and placed at the greatest distance from the
hole on the engine arm, as indicated in the figure.
Assemble the central bracket of the bar (A), position the longest screw included in the bag E (4) in line with the
hole of the just assembled bracket, and position one of the two screws included in the bag D (5) in line with the
hole of the engine arm, by putting the washers (6) (respectively included in the bag D and E) between them.
5
4
A
6
1
3
2