16
Lights Out Feature:
This feature will automatically shut off the backlight on the hand control after a
specified period of inactivity (approximately 15 seconds).
To activate
the “Lights Out Feature”, follow the procedure below.
1. Press and hold the (SP) button “M”, until the backlight starts flashing.
2. Press the key sequence: (S1) Backrest down, (S2) Backrest up, and (S5) SIT.
To turn off
the “Lights Out Feature”, repeat steps 1 – 2.
Hand Control Disable
Hand control disable, disables all functions on the hand control.
1. To disable, press and hold the program button (SP) for 4 seconds until the
backlight starts flashing. Then press button (S7).
2. To enable, press and hold the program button (SP) for 4 seconds until the
backlight starts flashing. Then press button (S7).
Function Lock
Should you ever want to limit the button function of your hand control, you can
use the function lock feature to disable all button function except for buttons (S7
and S9).
1. To lock function, press and hold the program button (SP) for 4 seconds until
the backlight starts flashing.
2. Press button (S1), press button (S2), press button (S3), press button (S6).
3. To unlock function, press and hold the program button (SP) for 4 seconds until
the backlight starts flashing.
4. Press button (S1), press button (S2), press button (S3), press button (S6).
Hand Control Inside Arm Routing
Note:
Not available on models routed through the chair pocket.
To move the hand control from one side to the other, follow the instructions
below.
1. Lift the bottom of outside
back from the Velcro on
the arm cross rail.
2. Remove the hand control
wire from the J-Clip.
3. Unlock the extension
wire, and separate.
Note:
This step disables all
lift chair functions.
4. Route the hand control
wire through the opposite
J-Clip.
5. Reconnect the extension
wire, and lock to secure.
Extension
Lock
Hand Control
J-Clip
J-Clip
P-Clip
a
uto
D
rive
with
e
CLiPse
-C
ontroL
o
Peration
-
ContinueD
