3
M
AKING
P
OWER
C
ONNECTIONS IN
Y
OUR
N
EW
L
IFT
C
HAIR
Models UC210, UC320, UC540-S, UC540-M, UC540-L, UC550-S, UC550-M,
UC550-L, UC620,
UC660, UC770, UC780, UC990
1. Remove AC/DC adapter (transformer) from packaging located under base of
chair.
2. Place two 9 volt alkaline batteries (not included) into the slots provided. Install
the wire connections on each battery.
3. Locate the extension wire secured to the shaft of the lift motor beneath the
chair. Connect the female end of the wire to the power cord coming out of the
motor. Connect the male end of the wire to the adapter.
4. Make sure all connections are tight. Plug the adapter wire into a standard
(115-120V A.C.) wall outlet.
C
HAIR
L
OCATION
You will want to place your chair in the room where it will be most convenient for
you, such as near the television, radio, reading light, end table, or other furniture.
Leave enough space between back of chair and wall or other obstruction to allow
chair to recline (about 18 inches for standard models, 25 inches for Stellar Comfort
models). Recline space needed may vary based on chair model.
Do not allow any objects to restrict movement of the footrest. Some carpets have
a high plush pile that can rub on the bottom of the footrest. This situation can
damage the mechanism. You can correct this situation by turning the levelers
(located under the front of the chair) to raise the footrest enough to clear the
carpet.
Your chair is equipped with a battery back up source. 2-9 volt alkaline batteries
must be installed. Once used, batteries must be replaced. Keep the telephone or
some means of communicating with someone within reach.
L.E.D. light
L.E.D. light
From motor
To outlet
115-120V A.C.
DC Power
Back view of
Transformer
Transformer
Plug
Install two 9 volt batteries
in transformer for battery
backup (See page 7)
(batteries not included)
Summary of Contents for Leisure UC320
Page 11: ...NOTES 10 ...
Page 12: ...NOTES 11 ...
Page 13: ...UltraComfort 401 BRIDGE ST OLD FORGE PA 18518 2323 PLACE STAMP HERE ...