Page 4 of 6
INSTALL THE LIGHTBAR
1. The magnetic lightbar should be positioned on the vehicle
’s roof where the magnets will
safely secure the lightbar. Before mount the lightbar to the roof, be sure the surface is
clean and clear of dirt, grease and debris.
2. Locate the desired location where you wish to mount the lightbar. For best results, you
should make sure the lens is unobstructed, so that the light can be seen 360 degrees.
3. If you need to move the lightbar, hold one side securely, then lift the other side of the
lightbar from the room and move; repeat procedure to move the other side.
OPERATION
1. To turn on the lightbar, insert the 12V plug into the vehicles power outlet.
Press the on/off button on the back on the 12V plug. When the lightbar is operating, the
LED on the plug
’s switch will illuminate.
2. To change the pattern, press the button beside to the on/off button. Memory function
keeps same pattern selected, even when the lightbar is turned off.
3. To turn off the lightbar, remove the 12V plug from the vehicle
’s power socket or position
the on/off switch to off.
The 12V plug has a built-in fuse to protect the lightbar and the vehicle. If the lightbar does not
turn on when the plug is inserted into the vehicle power socket, check the fuse built into the
power plug by the following method: The tip of the power plug has a chrome push-in contact
which is secured by a black nut. Unscrew the nut which will give you access to the fuse. If the
fuse needs to be replaced, use a 5-Amp fuse. Follow the reverse procedure to re-assemble
fuse back into power-plug. (See Figure 1)
MAINTENANCE
•
It is recommended that the general condition of the lightbar be examined before it is
used. Keep your lightbar in good repair by adopting a program of conscientious repair
and maintenance. Have necessary repairs made by qualified service personnel.
•
Clean the surface of lightbar lens frequently to keep its brightness.
•
When any malfunction occurs, stop using and repair it immediately as soon as
possible. Please operate your lightbar according to the proper operation procedures.
Figure1
Figure 2
Mounting Surface
