MCS-100
2
Version A
SECTION 1: SYSTEM LAYOUT
SECTION 2: SYSTEM CONNECTION
Diagram #1: Tilt Switch or External Sensor Connection
You can connect any external trigger devices. Make sure negative trigger output of external device is connected to
Negative Trigger Input Wire (Green #4).
Diagram #2: LED Connection
1. Locate a stock replacement part of motorcycle. Drill 1/4" hole, pull wires through and push LED.
2. Connect wires as shown.
Diagram #3: Starter Interrupt and Ignition Connection
1. Locate the Starter wire.
1
3
5
7
8
6
4
2
Brown
Red
LED Output (+3V)
15 Amp Fuse
Ground
Light Output (+20 Amp)
- Trigger Input (-)
Ignition Input (+)
Light Output (+20 Amp)
Starter Interrupt Output (+)
Black
White
Green
Yellow
White
Orange
+12V DC Power
Tilt Switch or Sensor (Diag. #1)
Park or Signal Light (Diag. #4)
Connect to Battery Ground
Park or Signal Light (Diag. #4)
Ignition Wire (Diag. #3)
Start Wire (Diag. #3)
1
3
5
7
2
4
6
8
3V LED (+) Wire (Diag. #2)
Optional Tilt Switch
(Mercury or contact switch)
Green
4
Optional Shock Sensor
Optional Motion Sensor
Or
Or
Brown
Black
Ground
Brown
2
