+
-
Step #1 Step #2
Step #3 Step #4
Carefully remove the
screw from back of
the remote.
Remove top case
then replace the
battery.
Replace top case.
Re-install screw.
Test remote for
proper operation.
The transmitter battery should be changed at least once every year to maintain proper operating range.
Replace with quality23A 12volt Alkaline battery.
Battery Replacement
Plug the Connectors into the Module
.
Press the transmitter buttons to check for proper operation. Once it is
determined that everything is working correctly the module can be mounted.
NOTE:
Before plugging the module in make sure that Ignition Key is in the OFF
position.
STEP 1
- The following wires MUST be connected for proper operation.
STEP 2
- CONNECT AND MOUNT THE MODULE
(Optional Connections)
Mount the module
by selecting a location under the dash that is secure. Be
certain that the module does not obstruct any serviceable areas. The module
must be free from moving parts such as brake, clutch and gas pedals and the
linkages that are attached to them.
Lock
Trunk
Unlock
Basic remote operations*
*See Owners Manual for more transmitter operations
INSTALL MANUAL
REMOTE VEHICLE KEYLESS
PAGE 4
Quick Start Installation
Red (+15amp) 12volt Input
Connect to constant 12volt power source
Yellow (+) Ignition Input
Connect to switched 12volt power source
White (+15amp) Park Light Output
Connect to positive park light source
Black (-) Ground Input
Connect to chassis ground
Green (-) Lock Output
Negative 500ma door lock output
Blue (-) Unlock Output
Negative 500ma door unlock output
Orange (-500ma) Starter Disable Output
Connect to starter disable relay
Brown (-500ma) Horn Output
Connect to horn relay
Grey (- 500ma) Trunk Output
Connect to trunk release relay
Pink (-550ma) 2nd Unlock Output
Connect for drivers door priority
