ALARM STATUS / DIAGNOSTICS
PARK LIGHTS
LED FLASHES
DIAGNOSTICS / STATUS
3 SLOW FLASHES
LED’s ON SOLID
SYSTEM IS IN SERVICE MODE.
4 SLOW FLASHES
SERIES OF 8 FLASHES
NOT SET IN RESERVATION MODE “M” MODELS
5 SLOW FLASHES
SERIES OF 5 FLASHES
START ATTEMPT WHILE IGNITION IS ON
5 FLASHES
SERIES OF 5 FLASHES
START ATTEMPT WITH HOOD SWITCH OPEN
6 FLASHES
SERIES OF 6 FLASHES
START ATTEMPT WITH BRAKE APPLIED
7 FLASHES
SERIES OF 7 FLASHES
SYSTEM IS IN TACH LOCK OUT (SEE DEALER)
8 FLASHES
SERIES OF 8 FLASHES
THREE START ATTEMPTS WITH NO START
Diagnostic Mode is a tool that can help trouble shoot a start fault. If the remote starter fails to
start i.e.: the hood is open the park likes will flash a diagnostic code. i.e.: 5 flashes = start
attempt with hood open. If the vehicle does not remote start, count the park light flashes then
compare it to the chart below.
The start fault must be corrected in order for the system to operate correctly. See your dealer
for additional trouble shooting or visit
and visit the support page..
www.ultrastarters.com
TROUBLE SHOOTING
The LED's do not turn on when Tach Learning?
1)
The Tach wire input may be connected to the wrong wire. Check the Tach location and
connection then "reset and relearn".
2)
The system may be in Tachless Mode. On TL models the Tach wire connection is optional and
the LED's do not turn on during the 35 second learn procedure.
When I unlock the doors the windows roll down or the Trunk Pops?
This issue is caused by the length of the unlock pulse. To correct this issue program the system
for short door lock pulses. (125ms)
The alarm activates 30-45 minutes after setting it?
To prevent the vehicles battery from going dead the computer will "hibernate" like your home
computer might. In some vehicles this causes the door pin input to change state. The alarm
detects the change of state and activates. A relay must be installed to isolated the door pin
circuit from the alarm.
The starter motor stays engaged to long when remote started?
Reset then relearn the Tach with the transmission in reverse. If the vehicle is tach learned when
the idle is high the starter motor may "drag". Check your ground connection if issues persist.
SYSTEM PROGRAMMING -
Menu 1
PAGE 26
90 & 95 SERIES
OWNER'S MANUAL
DIAGNOSTICS
Applicated Security Technologies, Inc. ("AST") promises to the original purchaser to repair or replace with
a comparable reconditioned model any AST control module ("module") excluding without limitation the
any other accessories, including but not limited to the antenna, remote, siren and wiring harness, proves
to be defective in workmanship or material under reasonable use during the lifetime of the vehicle it was
originally installed, provided the following conditions have been met: the module was professionally
installed and serviced by an authorized AST dealer; the unit will be professionally reinstalled in the
vehicle in which it was originally installed by an authorized AST dealer; the warranty information card was
sent to AST within 10 days of the original installation date. Any warranty returns include a warranty return
authorization number issued by AST, original bill or sale and be pre-paid shipped directly to AST. After an
initial period of 2 years from the date of installation, AST reserves the right, at its sole discretion, to
charge a warranty processing fee of $30.00 USD. AST does not cover the cost for return freight on
warranty items, this cost is the sole responsibility of the purchaser.
All components included with the original packaged unit other than the module, including but not limited to
the siren, antenna and the remote transmitters, carry a one-year warranty from the date of purchase of
the same. Any warranty returns on components must include a warranty return authorization number
issued by AST, original bill or sale and be pre-paid shipped directly to AST. This warranty is non-
transferable and is automatically void if: the original purchaser has not completed the warranty card and
mailed it within ten (10) days of the date of purchase to the address listed on the card; the unit's date
code or serial number is defaced, missing or altered; the unit has been modified or used in a manner
contrary to its intended purpose; the unit has been damaged by accident, unreasonable use, neglect,
improper service, installation or other causes not arising out of defects in materials or construction. The
warranty does not cover damage to the unit caused by installation or removal of the unit. AST, at its sole
discretion, will determine what constitutes excessive damage and may refuse the return of any unit with
excessive damage, including, but not limited to, overloading, moisture and physical damage.
To the maximum extent allowed by law, any and all warranties are excluded by the manufacturer and
each entity participating in the stream of commerce therewith. This exclusion includes but is not limited to,
the exclusion of any and all warranty of merchantability and/or any and all warranty of fitness for a
particular purpose and/or any and all warranty of non-infringement or patents, in the United States of
America and/or abroad. Neither the manufacturer or any entities connected therewith shall be responsible
or liable for any damages whatsoever, including but not limited to, any consequential damages, incidental
damages, damages for loss of time, loss of earnings, commercial loss, loss of economic opportunity and
the like. Notwithstanding the above, manufacturer does offer a limited warranty to replace or repair the
control module as describe above.
Some states do not allow limitations on how long an implied warranty will last or the exclusion or limitation
on how long an implied warranty will last or the exclusion or limitation of incidental or consequential
damages. This warranty gives you specific legal rights, and you may also have other rights, which vary
State to State.
WARRANTY
SYSTEM PROGRAMMING -
Menu 1
PAGE 27
90 & 95 SERIES
OWNER'S MANUAL
WARRANY
