Press Once to Lock the doors and arm the alarm. Hold for Panic Mode.
Press a second time and hold for Constant Lock Output.
Press Once to Lock and arm the alarm. Hold for Panic Mode.
Press a second time and hold for Constant Lock Output.
Press once to unlock the doors and disarm the alarm
Press and hold for the Trunk / Aux Output
Press once to unlock the doors and disarm the alarm
Press and hold for the Trunk / Aux Output
Press this button to activate the 4th channel output.
This output can be used to activate additional alarm features.
Press this button to activate the 4th channel output.
This output can be used to activate additional alarm features.
Press once and hold for Car Finder
Press and release then hold to activate/deactivate Service Mode.
Press once and hold for Car Finder
Press and release then hold to activate/deactivate Service Mode.
Second Car Operation (Optional)
First Car Operation
First Car
2nd Car
=
=
=
=
&
&
&
then
then
Step 1
- Within three seconds turn the ignition ON-OFF-ON-OFF-ON -
Leaving ON.
Step 2
- Press and hold the Program Switch - Parking Lights will come ON **if park-lights do not
come on at this point, turn key off for 5 seconds, then repeat step 1.
Step 3
- Continue to hold the Program Switch, the park lights go out. (Continue holding switch)
Step 4
- Press the
LOCK
button on each of
1st car
remote’s and press the
#
button on Each of
the
2nd car
remote’s of the transmitters to be programmed pause for about 2-3 seconds
between each remote. The park lights will Flash once and the siren will chirp once each
time a new code is learned.
Note: Pause for 2-3 seconds between transmitters
All the transmitters
to be used must be
programmed at the same time.
All transmitters not programmed at this time will be erased
from memory for security. The system holds a maximum of 3 transmitter codes including
2nd car remote codes.
You can program the same remote as a 1st car remote in one vehicle and
as a 2nd car remote in a second vehicle.
Transmitter Programming
PAGE 10
SECURITY SYSTEM
INSTALL GUIDE
#
#
When the Battery Icon on the remote indicates that the battery is low the battery should be changed
promptly. Replace with quality 1.5volt “AAA” battery.
Battery Replacement
1
1 2
2 3
3
4
4
y
B
a
tt
e
r
Slide
a
te
r
y
B
t
Lift
Slide
e
r
y
B
a
tt
Positive
Negative
