Emergency Service Mode - (Valet)
This feature will disable the system except for locking and unlock functions.
This mode can also used if a remote is lost, damaged or if the system malfunctions.
ENTERING SERVICE MODE
1. While the ignition is “On” press and hold the Program button on the antenna for 5 seconds or until the horn
(optional) honks
5
times.
EXITING SERVICE MODE
1. While the ignition is “On” press and hold the Program
button for 5 seconds or until the horn (optional) honks
2
times.
Note:
Remote starter functions will be disabled and the LED will be “on” steady.
The door locks and the trunk release will still be operational.
Ignition
“On”
7 sec.
ATTENTION:
THE SYSTEM MUST BE PLACED INTO SERVICE MODE BEFORE ANY UNDER HOOD SERVICING IS DONE TO
THE VEHICLE. IT IS THE RESPONSIBILITY OF THE VEHICLE’S OWNER TO INSURE THAT THIS IS DONE. THE
MANUFACTURER ACCEPTS NO RESPONSIBILITY FOR ACCIDENTAL STARTING WHILE VEHICLE IS BEING SERVICED.
Battery Replacement
1
Lift
Slide
+
-
Transmitter Operation
1
2
3
4
Press Once to Lock Doors and arm the alarm (if equipped)
Press 2nd Time & Hold for Constant Lock Output
Press and hold for 3 seconds to activate Panic Mode
Press Once to disable Panic Mode
Press Once for Unlock doors and Disarm Alarm (if equipped)
Press & Hold for Trunk / Aux Output
Press Once for Start - (
2 Times if programmed for Safety Start
)
Press & Hold for 3 seconds while running to turn off
While running with the key, press the button to activate Idle Mode
Hold for 3 seconds to enter User Programmable Features
Press and release button 4 then press and hold button 3 for three seconds
to activate the Timer Mode
Press both buttons for 3 seconds to activate Car Finder Mode
1
2
2&3
3
4
PARK LIGHTS
STATUS LED
DIAGNOSTIC CODE
3 Flashes
Series of 3 Flashes
Door Opened “M” Models
3 Slow Flashes
No Flashes
Start Attempt In Service Mode
4 Slow Flashes
Series of 4 Flashes
Not in Reservation Mode “M” units
5 Flashes
Series of 5
Flashes
Hood Pin Grounded (Open)
6 Flashes
Series of 6 Flashes
Brake Pedal Shutdown
7 Flashes
Series of 7 Flashes
Tach Lock-Out
8 Flashes
Series of 8 Flashes
3 Start Attempts with no start
DIAGNOSTICS
System Service Mode - By Remote
ACTIVATE Service Mode (User Programmable Feature)
1 - Press and hold button #4 for 3 seconds. (The remote will beep twice)
2 - Press button #1 Five times or until the
?
starts flashing on the LCD screen.
3 - Press button #3 and the
?
symbol will come on solid.
4 - Press button #4 to exit User Program Mode.
(System Is Now In Service Mode)
DEACTIVATE Service Mode
1 - Press and hold button #4 for 3 seconds. (The remote will beep twice)
2 - Press button #1 Five times or until the
?
starts flashing on the LCD screen.
3 - Press button #2 and the
?
symbol will turn off.
4 - Press button #4 to exit User Program Mode.
(Serice Mode is Deactivated)
The battery icon on the remote will indicate the present level of the transmitter battery. When the
transmitter indicates the battery is low it should be replaced. Replace with quality 1.5volt “AAA” battery.
Timer Mode
1.Press & release button
#4,
then press and hold button
#3
for 5 seconds, the lights will turn “On”.
2. While the parking lights are “on” the start cycle can be selected.
1 hour cycle
Press button #1 1 Park light flash
2 hour cycle
Press button #2
2 Park light flashes
3 hour cycle
Press button #3 3 Park light flashes
4 hour cycle
Press button #4 4 Park light flashes
3. The system will start vehicle at selected start cycle for a period up to 24 hours.
Owner’s Guide
Owner’s Guide
