PROGRAM MODE - ALARM SETTINGS
Enter Alarm Program Mode - See Page 7 for details on entering program mode
Press the Program Button 1 time
to select setting 1 (This will be confirmed by 1 LED flash)
Press and hold the Program
Button
until you receive the appropriate # of park light flashes and siren chirps.
Release the Program Button .
Press momentarily to move to next program step or repeat to change selection.
Press the Program Button 2 times
to select setting 2 (This will be confirmed by 2 LED flashes)
Press and hold the Program
Button
until you receive the appropriate # of park light flashes and siren chirps.
Release the Program Button .
Press momentarily to move to next program step or repeat to change selection.
Press the Program Button 3 times
to select setting 3 (This will be confirmed by 3 LED flashes)
Press and hold the Program Button
until you receive the appropriate # of park light flashes and siren chirps.
Release the Program Button .
Press momentarily to move to next program step or repeat to change selection.
Press the Program Button 4 times
to select setting 4 (This will be confirmed by 4 LED flashes)
Press and hold the Program Button
until you receive the appropriate # of park light flashes and siren chirps.
Release the Program Button .
Press momentarily to move to next program step or repeat to change selection.
Press the Program Button 5 times
to select setting 5 (This will be confirmed by 5 LED flashes)
Press and hold the Program
Button
until you receive the appropriate # of park light flashes and siren chirps.
Release the Program Button .
Press momentarily to move to next program step or repeat to change selection.
1 30 Second Parking Lights on Disarm 1 Flash
Park Lights on for 30 seconds on disarm
2 Negative Park Light
2 Flashes
Switches the Park Light and the Trunk Release (3rd Ch) Outputs
3* Normal Parking Lights
3 Flashes
2 Park Light Flashes on disarm
1 5ms 1 Flash Short (Quiet) Pulses
2 20ms 2 Flashes Long (Loud) Pulses
*3 10ms 3 Flashes Normal (Medium) Pulses
Setting 3 Horn Honk Timing - Unit Must be set for Horn Output in Setting 5
1 Secure Valet Active
1 Flash
Valet only if ignition “ON” and Program Button is held for 15 seconds
2* Normal Valet Active
2 Flashes
Valet if ignition “ON” and Program Button is held for 5 seconds
Setting 1 - Secure Valet Mode
Setting 2 - Parking Light Output
1Door & Button 1 Flash
Activated by pressing Button #4 or opening the door while the Ignition is “ON”
2Door, Button 4 2 Flashes
Activated by pressing Button #4 or opening the door while the Ignition is “ON”
*3 Car Jack OFF 3 Flashes No Car Jack
1 Horn Honk 1 Flash Pulses when alarm is triggered - Timing can be programmed by Setting 4
*2 Siren Output 2 Flashes Output on steady when alarm is triggered
Setting 4 Car Jack Mode
Setting 5 Siren / Horn Output
PROGRAMMING
PROGRAMMING
PROGRAMMING
INSTALLATION GUIDE
