01622 933 853
www.ultra-soft.co.uk
Preparing The Softener To Go Into Service
Ensure turbine cable is clipped into outlet pipework. Put
approximately 5 litres of water into the brine tank. You may
also at this point put a quantity of salt into the tank. Do not
allow the salt level in the brine tank to exceed the height of
the overflow. You should keep the salt level above the water
level and check the salt level on a regular basis until a
usage pattern has been established.
Water Softener Controller
If the version of the softener you have bought comes with a
remote controller insert the batteries. The controller allows
for remote control over the softener. To link the remote
controller, on the controller press "up" and "down" button
for 3 seconds, then press "down" to find SETID.
At this time, connect the power on the softener. Press the
confirm button on the remote controller and wait to hear
"Di" sound, it means the connection is successful.
The display shows information on the remaining capacity of
the left and right tanks, the current flow rate from the
softener and the time. You can use the controller to begin a
manual regeneration or to adjust the time and hardness
settings. This is done in the same manner as on the
softener. See programming and commissioning softener
section.
Programming The Valve
When plugging in the softener it will initially display the
valve model information then go to the main screen
showing the time, right and left tank capacities and whether
each unit is in service or regeneration.
