Applications
PURPOSE:
The rebar lanyards are intended to be used as part of work positioning system that holds and supports the user at a work location.
Applications include concrete rebar assembly and steel erection. OSHA standard 1926.500 defines this equipment as part of a positioning device
system.
LIMITATIONS:
Consider the following application limitations before using this equipment:
1.
CAPACITY:
This equipment is designed for use by persons with a combined weight (including tools, clothing, etc.) of no more than 400 lbs.
2.
FREE FALL:
This equipment must be rigged to limit the potential free fall to 2 feet, according to OSHA 1926.502.
3. FALL CLEARANCE:
Ensure that adequate clearance exists in your fall path to prevent striking an object. The clearance required is
dependent on the length and type of lanyard and anchorage location.
4. PERSONAL FALL ARREST SYSTEM:
Ultra-Safe recommends the
use of a personal fall arrest system with this equipment.
The personal fall arrest system will protect the user if the work
positioning system disengages from the anchorage point, or
when detached from the work positioning system when moving
from point to point. See OSHA 1926.501 and 1926,1053.
5. ENVIRONMENTAL HAZARDS:
Use of this equipment in areas
where environmental hazards are present may require additional
precautions to reduce the possibility of injury to the user or
damage to the equipment. Hazards may include, but are not
limited to; high heat, sever cold, caustic chemicals, corrosive
environments, high voltage power lines, explosive or toxic gases,
moving machinery, or sharp edges.
6. TRAINING:
This equipment is intended to be used by persons
trained in its correct application and use.
APPLICABLE STANDARDS:
Refer to national standards, including the ANSI Z359 family of standards on fall protection, ANSI A10.32, and applicable
local, state, and federal (OSHA) requirements governing occupational safety, for more information on work positioning systems.
ANCHORAGE STRENGTH:
Anchorages selected for work positioning systems shall have a strength capable of sustaining static loads applied in the
directions permitted by the system of at least: 3,000 pounds (13.3kN) for non-certified anchorages or Two times the forseeable force for certified
anchorages.
MAINTENANCE, SERVICING, STORAGE
Clean the rebar lanyard with water and mild detergent. Wipe off hardware with a clean, dry cloth and hang to air dry. Do not force dry with
heat. An excessive build-up of dirt, paint, etc., may prevent the rebar lanyard from working properly, and in severe cases, weaken the webbing.
If you have questions about the condition of your rebar lanyard, contact Ultra-Safe.
Additional maintenance and servicing procedures must be completed by Ultra-Safe or parties authorized in writing. Do not disassemble this
equipment.
Store the rebar lanyard in a cool, dry, clean environment, out of direct sunlight. Avoid areas where chemical vapors are present.
Thoroughly inspect this equipment after extended storage.
2
WARNING!
This product is part of a personal fall arrest system. The user must read and follow the manufacturer’s instructions
for each component of the system. These instructions must be provided to the user of this product. The user must
read and understand these instructions before using this product. Manufacturer’s instructions must be followed for
proper use and maintenance of this product. Alteration or misuse of this product, or failure to follow instructions may
result in serious injury or death.
