3461/07/01 ISSUE 2
PRINTHEAD INSTALLATION & COMMISSIONING SPEC.
DCR No. 26106
III
1.
(b) Removing the cover
Magicard Turbo models.
(1)
Set the printer On/Off switch to Off(O) and isolate from the mains supply. Remove the
card cassette and the Dye-Film from
the printer.
(2)
Position the printer upside down
with the rear of the printer facing
towards you and remove the four
securing screws from the base of the
printer plus the eight at the rear of
the printer.
(3) Position the printer with the front panel
facing upwards. Remove the two screws from
the underside of the front panel and remove the
two screws from the top left and top right of the
front panel.
(4)
Turn the printer back onto its base and
lift off the front cover. Using an M4
spanner loosen the bolt at the right hand
end of the Door Locking Shaft and
disconnect the operating lever from the
shaft.
(5) Flex out the sides of the cover and lift it
carefully away.
