3461/07/01 ISSUE 2
PRINTHEAD INSTALLATION & COMMISSIONING SPEC.
DCR No. 26106
II
1.
(a) Removing the cover
Magicard 300 and Sprinter models.
(1) Set the printer On/Off switch to off(0) and isolate from the mains supply. Remove the
card cassette and Dye-Film from the
printer.
(2) Position the printer on its side with the
rear of the printer facing towards you
and remove the five securing screws
from the base of the printer plus the
two at the rear of the printer.
(3) Place the printer on its base with the front
of the printer facing towards you.
(
4) Lift the printer cover from the rear and
carefully remove it from the printer
taking care not to strain the ribbon cable
connection from printer circuit board
PL8, and place the cover aside.
