Place the feed screw into the head, long end first, by turning the feed screw slightly
until it is set into the motor housing. (fig.3)
Place the cutting blade onto the feed screw shaft with the blade facing the front as
illustrated. (fig.4) If it is not fitted properly, meat will not be ground.
Place the desired cutting plate next to the cutting blade, fitting protrusions in the
slots. (fig.5)
Support or press the centre of the cutting plate with one finger then screw the fixing
ring until tight with another hand. (fig.6) Do not over tighten.
Place the hopper plate on the top of the head and fix into position.
Locate the unit on a firm place.
The air passage at the bottom and the side of the motor housing should be kept free
