2. Setting the ball joint for the
desired tilt angle
n
Loosen the little
wheel on the ball
joint
[
behind the
holder and set the
desired vertical or
horizontal position,
as well as the tilt
angle. Then tighten
the little wheel again.
3. Attaching a device to the holder
n
The lower holding tabs
{
can be adjus-
ted to fit the size of the device.
The tabs
{
can be pulled out and
pushed in by pressing the buttons on the
back of the holder
]
(marked “Press”).
Adjust both the holding tabs to fit the
size of your smartphone and make sure
that both the holding tabs are set the
same.
n
Insert the desired device and press
against the clamp
|
. This will give and
the device will simply be held by the hol-
der
]
. Now remove the pressure from
Holder
adjustable
holding tabs
LB5_160255_INT_Smartphonehalter_E_I_P_GB_D_160704.indd 30
07.07.16 10:05
