12 GB/CY
4 . Push the drain hose (ø 12 mm)
11
onto the
drain hose connector 6 .
5 . Secure both hoses 9 ,
11
with the supplied
hose clamps
10
. Make sure the hose clamps
are fitting tightly on the hose .
6 . Pay attention to the pumping direction
on the appliance .
m
Make sure that the hoses
9
,
11
are
straightened to avoid damage.
Operation
1 . Start the vehicle and run it for 5-10 minutes
to warm up the oil (60 °C is the maximum oil
temperature) . This reduces viscosity of the oil
and enables to pump it out more efficiently .
m
Do not pump the oil when the car
engine is running.
2 . Gently insert the suction hose (ø 6 mm) 9
into the bottom of the oil pan . (e .g . by the oil
level test opening) .
3 . Insert the drain hose (ø 12 mm)
11
into a
container (e .g . oil collecting tray) .
4 . Set the on/off switch
1
to “O” (off)
position .
5 . Connect the positive pole clamp (red)
4
to
the positive pole (+) of the vehicle battery .
6 . Connect the negative pole clamp (black)
5
to the negative pole (‒) of the vehicle
battery .
7 .
Turning on:
Set the on/off switch
1
to “I”
position . The pumping begins after a short
suction period .
8 .
Turning off:
Set the on/off switch
1
to
“O” . Turn the appliance off as soon as oil
extraction is over or after 30 minutes of
continuous operation .
9 . After each use, pump through some fresh oil
to clean the appliance .
10 . Disconnect both clamps
4
,
5
from the
vehicle battery .
m
To prevent damage let the appliance
cool for at least 10 minutes after
every 30 minutes of continuous
operation.
11 . Change the oil filter and refill with new oil
according to the vehicle instructions .
12 . Used oil needs to be disposed of in a way
according to “Disposal” .
Cleaning and maintenance
m
Warning!
During cleaning or operation
do not immerse the electrical parts of the
appliance in water or other liquids . Never
hold the appliance under running water .
Cleaning
1 . After each use, pump through some fresh oil
to clean the appliance .
2 . Clean both clamps
4
,
5
with a dry
cloth after each use . Make sure there is no
adhering battery fluid left on the appliance .
3 . Keep the casing
2
and accessories clean .
Do not use abrasive, aggressive or chemical
cleaning agents to clean the surface of the
appliance .
4 . In case of oil spillage, clean it with a soft
cloth or a paper towel .
Maintenance
Check the hose clamps
10
for tight fit .
Before each use check the appliance and all
its accessories for any visible damage .
Apart from the occasional cleaning, the
appliance is maintenance-free .
Summary of Contents for 12 V UOP 12 C1
Page 3: ...A B 1 2 7 9 8 6 5 4 3 10 11 ...
Page 4: ...C 1 8 6 5 4 9 10 11 ...
