9
UASB 12 A1
GB
IE
Operating the seat cushion
♦
Plug the 12 V vehicle connector
4
into the cigarette lighter. The Power LED
5
illuminates.
♦
Turn the on/off switch
3
into position “I” to switch the seat cushion
on.
♦
Turn the on/off switch
3
into position “0” to switch the seat cushion
off .
♦
After using the seat cushion, disconnect the 12 V vehicle connector
4
from
the cigarette lighter.
NOTE
►
The seat cushion
also consumes power in standby mode and therefore
must be disconnected from the on-board power supply after use! Other-
wise, depending on the vehicle type, the battery will be discharged if the
motor is switched off .
Replacing the fuse
There is a fuse in the 12 V vehicle connector
4
for protecting the vehicle's on-
board power supply. If the product no longer works, check the fuse and replace
if necessary.
♦
Open the 12 V vehicle connector
4
by gently turning the fl uted screw
insert
C
anticlockwise (using pliers if necessary) and remove it.
♦
Now remove the connector tip
B
from the fuse
A
and remove the fuse
A
.
♦
Now place a new fuse of type F5AL 250 V into the 12 V vehicle connec-
tor
4
,place the plug tip
B
onto the slightly protruding end of the fuse and
screw the previously removed screw insert
C
back in.
NOTE
►
If the product still does not function, or the fuse blows again immediately,
there is a defect. Please then contact the Service Hotline (see chapter
Service
).
A
B
C
IB_100113_UASB12A1_LB3.indb 9
21.05.14 08:32
Summary of Contents for 100113
Page 3: ......
