background image

4. Important

4.1 Standards

Installation must be completed in accordance with the requirements of AS/NZS 3500.4 (AS/NZS3500.4.2).

National Plumbing and Drainage Code Hot Water Supply Systems 

– 

Acceptable Solutions

”, 

or in New Zealand, 

Clause G12 of the New Zealand Building Code, as well as any relevant local standards and regulations.

4.2 

A

uthorised Person/s

Installation must be completed by a qualified tradesperson who holds all relevant industry licenses and/or 

certificates required for the work completed during the installation process.

4.3 Safety

At all times the qualified tradesperson installing the Ultimate Solar system must adhere to occupational health 

and safety guidelines as outlined by Workcare/Workcover in your state and/or country, and other relevant 

industry associations.

The qualified tradesperson installing the Ultimate Solar system is responsible at all times for their own safety. 

Under no circumstances should any person attempt to install an Ultimate Solar SHWS without reading and 

understanding this operation and installation manual.

4.4 Water Quality

The working design of the Ultimate Solar Hot Water System helps protect the inner surface of the stainless steel 

cylinder because there is not a continuous supply of water borne dissolved solids being brought into the cylinder 

every time a hot water tap is turned on. 

The stainless steel tank in the Ultimate Solar system could be susceptible to damage from very poor quality 

water. 

It is important to check the water quality in your local area. If in doubt, contact your local water authority or 

have a water test completed. 

Where the water quality exceeds the following dissolved solids, hardness and chloride measure the Ultimate 

Solar SHWS should not be installed. 

Failure to meet this measure may result in your warranty being void.

Total dissolved solids: 600mg/litre or ppm

Total hardness: 200mg/litre or ppm

Chloride: 250mg/litre or ppm

Installation of a quality water filter that improves water quality may be appropriate. Please consult with a 

supplier of water filters and water treatment systems to determine the correct product. The use of a filter 

or water treatment system that does not improve water quality within the standards set may result in your 

warranty being void.

Summary of Contents for 1K HE3













Reviews: