52
3. Insert the middle tab of the nozzle cover through the slot in the print head fan bracket. From the inside of the print
head, apply pressure to the metal plate. At the same time, pull the tab through the bracket and plate until the seal
locks the cover in place.
Use flat tip or round tip tweezers to pull the tab through the metal plate. This makes this action easier, as the
tab may be difficult to reach by hand.
4. Pull the right side of the nozzle cover, fold the pocket over the edge of the metal plate, and push the silicone tab
under the metal tab of the print head fan bracket. Repeat this for the left side.
5. Push the front tab through the slot in the print head fan bracket, while applying pressure to the metal plate from the
inside of the printer. Make sure the seal is pushed through the plate, to lock the cover in place.
6. Close the print head fan bracket and check if the new nozzle cover is correctly placed. Slide your finger across the
bottom of the print head. If the nozzle cover easily detaches from the fan bracket, it is not correctly placed. Follow
steps 3 - 5 again.
If the nozzle cover is not placed correctly, it may get caught on the print. This could cause the fan bracket to
open during printing.
7. Insert both print cores, following the guide in the configuration menu.
8. With the front fan bracket closed, hold the nozzle cover at both sides and slightly move it left and right. The metal
place and nozzle cover will now align themselves with the print cores.
The nozzle cover should not easily detach from the fan bracket
It is recommended to check the placement and alignment of the cover by manually lifting and lowering the
second print core. To do this, move the lift switch on the right side of the print head. Check if the fan bracket
remains closed as the second print core is lowered.
