Installing the Extrusion Upgrade kit
Replacing the feeder
Note:
Do not trap any of the wires
next to the feeder motor. Ensure
that the wires run between the
motor and the frame.
• Attach the feeder motor
to the body with the feeder
mounting plate, using the
four new screws
(M3 x 10 mm) and the
washers from the old feeder.
• Place the feeder on the
back with the small lever on
the bottom and use the two
supplied screws
(M3 x 10 mm) with M3 rings
around it to attach it.
A C A D E M Y
• Remove the four screws (M3 x 25 mm) from the feeder. While
removing the screws, hold the feeder motor at the inside of the
machine to prevent the motor from falling down.
• Keep the screws and washers and set the feeder and motor
aside. You do not need the feeder and feeder motor anymore.
• Take the new feeder motor and apply some grease
(Magnalube) to the small gear. Make sure the entire gear is
covered with a thin layer of grease.
• Place the feeder motor with the wires down on the inside of
your Ultimaker and place the geared feeder mounting plate
with the hole at the bottom over the four screw holes on the
outside.