Ultimaker 2 Extended Installation Manual Download Page 4

Page: 4 / 4

Step 6

: Attach the Magnetic Base with heater attached to the Z-

carriage with the 3 leveling screws. Tighten finger tight with the thumb
nuts and Phillips screwdriver.

Step 7

: Attach the GeckoTek Build Plate to the Magnetic Base and

center it. Then follow the manufacturer’s recommended bed leveling

procedure with the Build Plate in place.

You are now ready to 3D Print with your GeckoTek Build Plate!

Summary of Contents for 2 Extended

Page 1: ...26 11 2017 Installation Guide Ultimaker 2 and 3 Magnetic Base Plate...

Page 2: ...he installation process please let us know Total install time is 5 10 mins You will need the following to complete the installation process M2x5 screws included Thin Phillips screwdriver Pliers or wre...

Page 3: ...iers remove the screws holding the back two clips on Set the screws and nuts aside for later Step 5 Attach the Magnetic Base to the stock bed heater using the included M2 5 Screws The mounting holes i...

Page 4: ...Tighten finger tight with the thumb nuts and Phillips screwdriver Step 7 Attach the GeckoTek Build Plate to the Magnetic Base and center it Then follow the manufacturer s recommended bed leveling pro...