20
KSP SHAFT PLATFORM
3.6.1.
Complete set
Formwork is connected to the main platform by
chains. While lifting the formwork, the main platform
is pulled by these chains
.
The chains are directly connected to the waler by
passing a pin E
20x70 through the chain’s last hole. In
case it is necessary to place the chain near the
GRAVITY PAWL area, it will be necessary to use an
additional LIFTING RING A16.
The connection to the vertical waler is done in the
same way but, in this case, if the vertical waler
adjustment eleme
nt is also used, one of the D40 d20
L47 collars (code 0661505) has to be removed.
3.6.2.
Separately
The formwork and the platform are not connected,
so finally they move independently.
To lift the main platform, this should be pulled from
the inserted pin.
For heavy formwork and platform
sets, it is recommendable to use
vertical walers
Each formwork system must be used
with its corresponding approved lifting
hook
