12
[Figure 3] - Turn gas control to “OFF”.
[Figure 4] - Press, hold and turn to low.
LIGHTING INSTRUCTIONS
WARNING:
Before lighting, remove weather cover and remove lid
when applicable.
WARNING:
DO NOT stand with your head or arms over the fire pit
at any time.
*MAKE SURE IGNITION BATTERY IS INSTALLED (See page 13)
1. Make sure gas control knob on unit is set to “OFF”. [Figure 3]
2. To ignite, push and hold gas control knob counter clockwise for
3 - 5 seconds while turning to “LOW” and once ignited continuing to
depress the gas control knob for an additional 5-10 seconds before
releasing. The flame should stay lit. This will actuate the thermocouple.
[Figure 4]
NOTE: The built in thermocouple safety device needs to warm up to
engage, ensuring the gas will be shut off in the event of the unit being
tipped over or blown out.
4. Adjust flame to desired level with the gas control knob on the unit.
5. After operation, turn gas knob to the “OFF” position.
IF BURNER DOES NOT IGNITE:
If ignition is not immediate, push and turn the control knob
clockwise to “OFF”. The gas supply will automatically shut off after
approximately 10 seconds (+/- 3 seconds) if a flame does not start or
it is extinguished. If this happens, wait 5 minutes for gas fumes to clear
and re-try or refer to the troubleshooting section if the unit does not
re-start. If problem cannot be resolved, do not attempt to operate the
appliance; contact your dealer or approved service center.
