11
[Figure 2] - Turn gas control to “OFF”.
[Figure 1] - Install one AAA battery inside the unit.
[Figure 3] - Insert LP gas canisters inside
unit.
SETUP INSTRUCTIONS
REGULATOR CONNECTIONS:
Your Ukiah Co gas fire pit is equipped with a specialized pressure
regulator, which is a device to control and maintain uniform gas
pressure as gas is released from the LP cylinder. This pressure
regulator is designed for vapor withdrawal.
WARNING
: Use only the original specially designed regulator
supplied with your unit. Using another regulator may be dangerous.
WARNING
: Use canisters that are marked “Propane Fuel” only.
WARNING
: Read carefully all instructions contained on the
information plate attached to the fire pit.
WARNING
: Do not transport fire pit with LP canisters connected.
IGNITION BATTERY INSTALLATION
1. Install one AAA battery for the electronic ignition located inside of
the unit (AAA battery included). Unscrew igniter cap counterclockwise,
insert battery with positive side facing out, then tighten igniter cap
back on (make sure the battery is installed the proper direction).
[Figure 1]
1. Place fire pit in the desired location. Make sure that it is placed
outdoors in a well-ventilated area away from any flammable structures,
awnings, vegetation, etc.
2. Before installing LP tanks, make sure the unit gas control knob is
turned to “OFF” by pushing it in and turning the knob clockwise to the
off position. [Figure 2]
3. Remove the wooden lid and turn the fire pit over so that you can
access inside the unit.
4. Locate the two threaded gas fittings inside the fire pit and install
both 1-pound LP canisters by turning them clockwise until snug.
[Figure 3]
LP Canister REMOVAL:
When the LP canister needs to be replaced, follow these instructions
to remove it.
1. Make sure gas control knob is turned “OFF” by pushing it in and
turning it clockwise to the off position.
2. Remove both 1-pound LP canisters by turning them counter-
clockwise.
