UK-electronic Unicord SuperFuzz Clone, Build Manual

Page: 5 / 11

When the circuit board is finished, it is fitted to the assembly of the mechanical components in
the enclosure and the external wiring. Given that enclosure is already prepared with all the holes.
The LED is used so that the short leg (cathode) shows to the switch.
The 3PDT switch place in the enclosure so that the groove is either up or down in the thread of
the switch.
The input jack should be wired before that. (2 wires to ground (sleeve), ring
Æ
black wire from
the battery clip and tip of a wire, which then goes to the switch.
The wires from the battery clip you can cut the black and can then also take for Tip.
The connection switch
Æ
output jack provides you the easiest forth with a piece of wire cut from
a components.
This is all done, the prepared PCB with the potentiometers and the SPST switches are connected,
and the external wires from the switch and the power supply to the circuit board only needs to be
performed. This solder is conveniently right from the bottom of the corresponding points. The
attachment of the circuit board in the enclosure by means of the supplied self-adhesive spacer
directly on the two two potentiometer..
2013 © UK-electronic