UIC Bezel5 Programmer’s Manual
Page.69/166
UDN PM098 Rev. 1.0
Copyright © 2013, Uniform Industrial Corp. All Rights Reserved
Host Poll Mode transaction process Example flow
In this Example, assume the Bezel5 is in protocol USI2 and Self-Arm disable mode.
Host-Poll Mode
Enabled?
*H0/SAD
Command
Return Error Code?
P Command
Arm to Read
TM<01>
Command
Tap Card
54/55 Command
Set Transaction
Date/Time
T1 Command
Set Amount
S Command
Get TK3
Reader Initial
Start new
transaction
No
Error Code
Action
Receive error
from reader
Terminal/Controller
Action
Return Error Code Process
Terminal/Controller Action
Reader Setting Command
Reader Transaction Command
Tap Contactless Card
Yes
Yes
No
* Bezel-5 Plus has
Host-Poll mode
enabled set to
default.
Abort by Send <1B>
command
Error?
Figure 4-2. Host Poll Mode Transaction Process Example Flow
After the host issues the Arm-to-Read command, the Bezel5 will check if any payment card is
detected in the reading zone or any magnetic stripe card is swiped. No matter the card is decoded
successfully or not, it will return the ‘^’ to indicate that the card has been read. The host can issue
the ‘Q’, ‘R’, ‘S’ commands to retrieve the card data accordingly.
Related Commands:
Function
Reference
Host-Poll Mode setting
4.2.1. H (48H) – Self-Arm function disable/enable
4.3.19. SAx(53h 41h x)
－
Self-Arm Mode Enable/Disable
Set Transaction Date/Time
4.1.11. 5 (35H) – Set RTC Time
Return Error Code setting
4.3.22. TMx(54h 4Dh x)
－
Set Error Code output Enable/ Disable
