uhlmann & zacher CX6182, Assembly Manual

Page: 16 / 26

CX6182 C
OMMISSIONING
15
5 Commissioning
5.1 Managing the locking system
The locking system can be managed using the Keyvi management software.
Before a locking system unit can be used, it has to be personalized and the
settings have to be customized.
5.1.1 Personalization
Every door and key in the electronic locking system Clex prime should be known
to the management software for the respective locking system for subsequent
programming. This process is called personalization.
During the personalization, the door or the knob cylinder used in it is given a
door ID (D-ID) and the key is given a key ID (K-ID) by the Keyvi management
software
.
5.1.2 Changing the settings
The following settings can be changed:
 Authorizations (see chapter 3.1.1 Authorizations, page 5)

Time zones (see chapter 3.1.2 Time zones, page 6)
 Time

Engagement time (defines the time for which the knob cylinder remains
engaged after holding up an authorized key, see chapter 6.2 Opening the
door, page 16)
 Wake up sensitivity (see chapter 6.1 Automatic wake up, page 16)

Expiry date of a key (see chapter 3.1.3 Automatic expiry date, page 6)

Radio response of the knob cylinder (wake-on-radio mode)
The authorization settings have to be changed first in the Keyvi management
software for the individual knob cylinder or groups of knob cylinders. The
software consolidates these settings into tasks, which then need to be transferred
first to the service device or to ClexTouch. From there, they can be transferred to
the individual knob cylinders.
If the knob cylinder is located in a Keyvi radio network, then the transfer can also
be done via radio.
For additional information, refer to the documentation on CX6530 Keyvi
management software, CX6510 service device and CX6522 ClexTouch
.
5.2 Configuring the knob cylinder
Prerequisite: Tasks have been created in the Keyvi management software and
transferred to the service device or to ClexTouch.
 Hold the service key in front of the knob cylinder to switch the knob cylinder to
the service mode.

Using the service device or ClexTouch, send the respective job to the knob
cylinder (see operating manual of CX6510 service device or that of CX6522
ClexTouch)