Uhlenbrock Elektronik GmbH
Mercatorstr.6
D-46244 Bottrop
Made in Germany
These are your advantages
:
Service
In case of an eventual failure please return the defective item to us for
repair. Please include purchase proof and a short description of defect,
as well as stating the decoder’s address setting.
Hotline
In case of questions, we are ready to answer them for you!
Directly contact our technician:
+ 49 (0 ) 20 45 - 85 83 27
Mo - Fr except Wed 14:00 -16:00 hrs CET, Wed 16:00 -18:00 hrs CET
The figure 2 at the end of the item no.
means that this article is delivered with
an english discribtion.
Item no. 76 502
03.03 B e
All brand names mentioned are registered trademarks of the respective companies.
Warranty Statement
Every item is fully tested for functioning before shipment. If a defect occurs within two years
after purchase, the item will be repaired free of charge against presentation of purchase proof.
Damages caused by overload or improper treatment are not covered by this warranty.
For EU only: Please note that decoders may only used in models carrying the EC conformance
label.
www.uhlenbrock.de
Be it most recent information about Intellibox, a pricelist or a listing of authorized dealers, plus
various publications to download, our website warrants your visit in every case.
Using the offset-register to set CV values greater than 79
CV-values greater than 79 can only programmed by employing the offset-register. This is CV 63.
It holds a value offset that will be multiplied by 4 and added to all CV values keyed in.
Example
Consider CV 49 to be programmed for a value of 157. First CV 63 must be set to a value of 25.
Now CV 49 must be set to value of 57. The decoder will hold 157 in CV 49, because the offset
of CV 63 will be multiplied by 4 (=100) and added to 57. After programming, reset the contents
of CV 63 to zero in order to avoid unwanted offsets.
Observe
: When programming CV 63 and CV 64 the mutual contents are ignored.
Technical Data
Adress range
:
1-9999
(extended DCC address)
Max. motor current:
1 A
Ancillary outputs:
1 A each
Total load:
1 A
Size:
22 x 12,5 x 5 mm
The factory settings are address 03, 28 speed steps, and the decoder automatically recognizes
DCC- and Motorola-formats.
Factory Default Settings
As delivered the decoder automatically recognizes DCC/Motorola. Moreover the decoder can be
operated on conventional 2-rail DC or 3-rail AC (Märklin) layouts.