Ugur UDD 10 SF, Operating Instructions Manual

Page: 54 / 226

EN
F- YETKİLİ SERVİS ÇAĞRILMADAN ÖNCE YAPILMASI GEREKENLER
Troubleshooting
The failures and solutions stated in this section can be performed easily by yourselves and always consult to an Autho-
rized Uğur Service if these suggestions do NOTE solve your problem.
Ürünlerinizde kullanılan lamba veya ledlerin güç değerleri lambaların takılı olduğu bölümde olup
üründen ürüne değişiklik göstermektedir. Ürünlerinizde kullanılan lamba veya ledlere sadece Uğur
Yetkili Servisleri müdahale edebilir.
Troubleshooting Possible Solution Result.
Cooler is NOTE working. (No sound
or only fan sound comes from the
product.)
It may be due to the thermostat
NOTE plugged in. The fuse may be
blown or broken down.
Condenser lamella may be ob-
structed or get dirty.
It will run again when reached to
the suitable temperature.
Insert the plug properly.
Consult to an Authorized Uğur Ser-
vice or a competent electrician.
Clean the condenser lamellas.
Device internal temperature is high. External ambient temperature is
very high or wrong thermostat
setting.
Very close to the back wall, ventila-
tion shutters are obstructed or it’s
front is prevented.
It may have been expose to exces-
sive external wind.
Condenser lamellas are very dirty.
Move the cooler to a place where
the external temperature is lower.
Adjust to the stated gap.
Clean in front of the ventilation
shutters.
Prevent the wind.
Clean the condenser lamellas.
Device internal temperature is very
low.
Wrong internal thermostat setting. Re-set the thermostat.
High degree of sweating on the
glass and inside the device.
Water discharge hole may be
obstructed when sweating is seen
inside the cabin.
In glass sweating on the other hand,
current external ambient humidity
is over 65%.
Clean water discharge hole. With re-
gards to the high humidity, you can
move your cooler to an environment
with less humidity.
Bad smell coming from the bottom
part of the cooler.
Lower water discharge tray is dirty. Su tahliye tavasını temizleyiniz.
CAUTION!
• Intervention to any failure that may occur in your product must be carried out by Authorized Uğur Service.
• Any intervention that may be done by you may harm you, your employee or customer, invalidate the product
guarantee and cause material damage (fire etc..).
• In case of any failure, consult to Uğur Customer Care or Authorized Uğur Service. (see Page 20)
54