Instructions for use (rev 110121)
PC 30
UGIN DENTAIRE
20
4.2.
INSTALLATION
-
Install in a room aired. Observe the conditions indicated in chapter 3.2.
-
Place the furnace on a level and aired surface. Keep a distance from other objects around not less than
10cm. Keep it away from heat sources (for example, radiators and/or other equipment that release heat).
Avoid vibrations and shocks.
-
Do not install in a place with explosion hazard.
-
Its forbidden placing inflammables, toxic, volatile or explosives around the furnace.
This unit requires its own power line and has to be connected to a circuit breaker.
Grounding is mandatory
to avoid accidents and the dangers of overheating the power line.
Due to the power of furnace:
connect it directly to the mains
, do not use multiple sockets (risk
of electrical interference).
▪
Fumes extractor installation
UGIN DENTAIRE recommends installing a fumes extractor on the PC 30 in order to achieve optimal gas
evacuation. It will be installed in place of the chimney outlet. It is recommended to use the
UGIN DENTAIRE
fumes extractor
.
Installation procedure:
-
Remove the chimney outlet (No. 1): unscrew.
-
Instead install the fumes extractor: screw.
-
Make sure that the mains voltage complies with the voltage indicated on the rating plate, connect it to
the mains with an adapter cable to a 10/16A grounded power socket.
-
To start and stop the UGIN DENTAIRE fumes extractor: connect/disconnect the adapter cable from the
mains socket.
IMPORTANT:
with PC 30
only can be connected a fumes extractor which has an external control
independent of the furnace and a maximum power of 20W.
If non-observance of these instructions: risk of material damage (the resistance, particularly) and may
voids any warranty for your device.
4.3.
START-UP
NOTE: for marks, see chapter A
–
equipment description.
-
Connect the power cord to the power socket (No. 2).
-
Make sure that the mains voltage complies with the voltage indicated on the rating plate, connect the
power cord to a 10/16 A grounded power socket.
-
Activate the ON/OFF switch (No. 7).
