16
GF: Jürgen Scherrieble
Steuernummer 24/140/60001
VAt-No. DE 232257366
HRB 9186
Deutsche Bank Regensburg
BLZ 750 700 24
Kto.Nr. 32 92 935
SWIFT: DEUTDEDB750
IBAN: DE94750700240329293500
Warning: When the hand control is not in use, it should be hung up on one of the armrests or on
the metal rails attaching the armrests to the backrest. Proper storage will help to prevent the
accidental pushing of buttons, and will protect the cable from damage. For optimal storage and
accessibility, use the hand control in combination with the optional hand control holder.
- Hand Control Auto-run Function
–
When the “auto” button is pressed followed by one of the 4 memory position buttons, the chair will fully
automatically adjust itself to the selected position. The yellow LED light (the right light) will blink during the
motorized adjustment and will go off as soon as the end position is reached. If any button on the hand
control is pressed during this auto-adjustment, the chair will immediately stop in place.
Memory positions 1-4 are engaged by pressing
and holding down the respective button.
To Save a Memory Position:
1. Bring the Chair using buttons 2-6 to the
desired position
2. Press the Memo button until the right, yellow
LED light is lit up.
3. Finally, press the position 1 button. The
position is now saved as position 1.
Following the same series of steps, you can
save customized positions for the 2-4 buttons.
If at any time you would like to change a saved
memory position, simply bring the chair to the
new desired position using buttons 2-6, and then
save the position in the same way as previously
described.
A discharged battery can lead to the loss of
saved memory positions. If this occurs, charge
the battery fully, and then repeat the previous
steps above to resave lost memory positions.
After pressing the new auto-run function
button, it is possible to adjust the chair to the
any desired, pre-programmed position with
just a single button press.