INSTALLATION
7
UFO
LIGHTING
CONNECTION
-
FOR
DMX
OPERATION
There are 3 connections required – the fiber port, the mains supply cable and the DMX cables.
The fiber port should be connected first. Connect and secure the fiber optic connector into the
aluminium collar and secure using the M5 locking screw.
Connect the PSU to the DC input jack socket on the illuminator, and connect the IEC plug to the
PSU. Plug the mains plug into the electrical supply socket. Switch on power. The LED Indicator on
the PSU will illuminate and the illuminator is ready for use. If no light is produced consult the
TROUBLESHOOTING section of this user guide.
Connect to the 3 pin XLR sockets on the side panel as detailed below using an approved DMX cable.
Only approved DMX cables should be used.
Always “daisy chain” a DMX universe. Never use a T joint in a DMX universe unless using an
approved interface.
It is always recommended that the last illuminator output in the DMX universe or cable run be
terminated with a 120 ohm resistor across DMX+ and DMX-.
