Vertical and Horizontal Mount
Install Hose Clamp
Upright pole
Minimum OD 35mm
Maximum OD 110mm
Minimum OD 40mm
Maximum OD 120mm
Maximum 55Kg.cm torque for hose clamp
Horizontal pole
All product specifications are subject to change without notice
- 6 -
Horizontal direction clamp through hole
Upright direction clamp hole
Connecting Earth Ground to Unit
Warning
The equipment has a separate protective earthing terminal on the chassis that must be permanently connected to
earth ground to adequately ground the chassis and protect the operator from electrical hazards.
The product shall be installed by a qualified service person and the installation shall conform to all local codes.
Caution
Before equipment installation begins, ensure that a service personnel has attached an appropriate grounding lug to
the grounding cable that you supply.
Power installation must be performed with qualified electrician and followed with National Electrical Code,
ANSI/NFPA 70 and Canadian Electrical Code, Part I, CSA C22.1.
Warning
At first before powered on, connect the frame of the unit to earth.
For earthing wire, green-and-yellow insulation is required and the cross-sectional area of the conductor must be
more than 10 AWG.
1
Connect one end of the grounding cable to a proper earth ground.
2
Place the grounding lug attached to the grounding cable over the protective earthing terminal.
3
Secure the grounding lug to the protective earthing terminal with the washers and screws.
4
Dress the grounding cable and ensure that it does not touch or block access to other components.
To connect earth ground to Unit
