UFESA MONTREAL, Instruction Manual

Page: 15 / 48

15
INSTALLATION
• After removing the packing materials, check the integrity of the fan; if you are unsure, do not use
it and ask for qualified professional help. The packing materials (plastic bags, polystyrene foam,
nails, etc.) must be kept out the reach of children because they are potential sources of danger.
• Before connecting the appliance, check that the voltage values shown on the data plate corres-
pond to those of the electricity supply network. In the event of incompatibility between the elec-
tric outlet and the plug of the heater, have the outlet replaced with another more suitable type by
professionally qualified personnel, who will make sure that the section of the wires of the outlet
is appropriate for the absorbed power of the heater. In general, the use of adapters or extension
cords is not recommended; if their use is indispensable, they must conform to existing safety stan-
dards and their current capacity (amperes) must not be less that the maximum of the appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergen-
cy.
• To not place the appliance near sinks or other container of liquids (minimum distance of 2 meters)
to avoid the risk of it falling in.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air
intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or
wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the
appliance could upset).
• In the event of a breakdown or poor operation, turn the fan off and ask for professionally qualified
help.
HOW TO ASSEMBLE (MONTREAL /OTTAWA)
1. Fix the Stand (12) into the Base (15) with the Tightening Screw (14) and Nut (16) provided.
2. Adjust the Stand (12) to the suitable height you desire.
3. Put the Motor (5) into the Stand (12) and tighten it with Knob Set (8).
4. Take off the Rear Guard Nut (3) off the Motor (5) and put the Rear Guard (4) into the Motor (5)
and tighten it with the Rear Guard Nut (3).
5. Fix the Blade (2) into the Motor shaft.
6. Fix the Mark Plate (22) on the Front Guard (1) with the Mark Plate Screws (23).
7. Put the Front Guard (1) into the Rear Guard (4) and fix them together with the clip, buckles and
safety Fixing Screw (10) and Safety Fixing Nut (11).
HOW TO ASSEMBLE (OTTAWA 3 in 1)
1. For stand fan, its assembly is same as above.
Additional steps for Floor Fan:
2. Using Parts from Part 17,18,19,20,21 to make a full floor base.
3. Taking the head pre-assembled from the stand fan to fix on the floor base by using the Knob Set