UFESA Aqua Steam, Instruction Manual

Page: 17 / 56

17
The mains connection cable must not be tangled or wrapped around the product during use.
Do not use the device, or connect and disconnect to supply mains with the hands and / or
feet wet.
Do not pull on the connection cord in order to unplug it or use it as a handle
Do not direct steam at people and animals.
Do not place the appliance under the tap to fill the water tank, or immerse it in water or
other liquids.
Unplug the product immediately from the mains in the event of any breakdown or damage
and contact an Official Technical support service. In order to prevent any risk of danger, do
not open the device. Only qualified technical personnel from the brand´s Official Technical
support service may carry out repairs or procedures on the device.
Proceed according to the conservation and cleaning section of this manual for cleaning.
B&B Trends, S.L. disclaims all liability for damages that may occur to people, animals or
objects, for the non-observance of these warnings.
BEFORE THE FIRST USE
Before using the Steam Station, please ensure you read the user manual and understand
all parts and features of the Steam Station. Be sure to remove any packaging material and
labels before using for the first time.
In the first use they can break off odors or fumes that sent quickly. Do not spray for the first
time on clothes and there may be traces of dirt on the soleplate.
WATER TO BE USED
The device is designed for use with tap water. If the water in your area is hard or semi-hard
use mix tap water with distilled or demineralized water purchased in stores, in the ratio 2:1
and 1:1 respectively (distilled water: tap water). Check with your water supplier to determine
the type of water in your area.
Never use 100% distilled or demineralized, rain water, softened water, scented water, water
from other appliances such as refrigerators, air conditioners, dryers or other types of home
water preparation water.
FILLING THE WATER TANK
Fill it through the water inlet cover. Do NOT fill over the MAX level indicator. Make sure
when placing it back to the station that it fits correctly.
OPERATING INSTRUCTIONS
NB: If it is the first time you have steam-ironed or if the product has not been used for
some time, turn the temperature control to Max position and press the steam button
continuously until steam comes out. This process can take a few minutes.
Place the Steam Station on a firm level table, bench or ironing board.
Plug the unit into a power outlet and switch on at the power point.
Adjust the temperature dial in terms of choose the kind of fabrics that you want to iron.
Note: If you want to use the steam ironing, we suggest you to adjust the temperature dial on
MAX. When the iron operating light indicator goes out the device will be ready for use.