C50/C75-MAN
P. 5
N G Cond
1. Press “
ENTER
”.
2. Select “
N
” for Net, or “
G
” for Gross or “
COND
” to
calculate efficiency.
• Gross Efficiency uses the gross calorific value of the fuel and
deems that the latent heat of vaporization is lost up the flue
of the appliance and is taken as a loss. Gross is used in the
UK and USA
• Net Efficiency uses the net calorific value and assumes the
latent heat is not lost up the flue - For Natural gas this
efficiency can be 11% higher than the Gross Figure - Net is
used in France and Germany
• COND is for efficiency of condensing appliances
3. Press “
ENTER
” to save and exit.
PPM MG
1. Press “
ENTER
”.
2. Select “
PPM
” for parts per million or “
MG
” for mF/M3
(milligrams per cubic meter) using the up or down keys.
3. Press “
ENTER
” to save and exit.
SERVICE
1. The service mode is used for repair and calibration, and
should only be entered by authorized service facilities.
2. The firmware can be displayed by entering “
2222
” for
the code.
You may exit the menu at any time by rotating the selector to a
different position unless the final logical “
ENTER
” is pressed, no
changes are made.
The exception is: STORE DELETE where the “
ENTER
” key must be
pressed to confirm the change and exit. If you rotate the dial before
pressing “
ENTER
” the instrument will be continuously. You must rotate
the dial back to “
MENU
” and press “
ENTER
” before you can continue.
In STORE view mode the rotary dial is used to select the saved
parameter to be displayed. Use the “
UP/DOWN
” keys to change the
test number. To exit the view mode press “
ENTER
”.
Storing Test Results
At any time during a test you may store the readings in one of the 1
memory positions. Press “
||
” and hold for 2 seconds or more.
Printing Information
Supplied as an accessory for the analyzer is an infrared thermal printer.
Read the manual supplied with the printer prior to operation.
Connection to the analyzer is detailed below:
• Infrared thermal printer - this does not require a cable to
transmit the data but uses an infrared (IR) link similar to a TV
remote control. The IR emitter is positioned on the top of the
analyzer and the bottom of the printer. Ensure they are pointing
at each other and within 3 feet, with no obstructions in the way.
Data may be lost if transmission is interrupted. Keep the analyzer
pointing at the printer until the printout has finished.
Printing A Test
During combustion tests the analyzer can print data on request. With
the analyzer showing the data, press and hold the “ “ push-button
until “
PRINTING
” is displayed.
The standard printout is:
*C75 only
**C50 only
NOTE:
Printouts of stored
readings will also include
the TEST NO. below the
header.
EFF% (G) = gross
EFF% (N) = nett
EFF% (C) = condensing
SMOKE area on printout
is for adding data from
manual test.
UEI C75
16 character header
16 character header
503 644 8723
Date: 06-26-02
Time: 14:27
Fuel
NATU
GAS
O2
%
20.9
CO2
%
0.0
CO*
PPM
00
COa*
PPM
00
NETT.
F
----
AMB
F
----
EFF%
(G)
----
XAIR
%
----
LOSSES**
%
----
CO/CO2
----
PE %
O2 ref %
SMOKE................................................................
