4
b
atterieS
r
eplaCemeNt
This meter has been designed for use with alkaline batteries.
No other types of batteries are recommended. The analyzer is
supplied with 4 “AA” size alkaline batteries. These should be
installed into the instrument as shown in the diagram to the
right and indicated on the back of the unit.
CAUTION!
Take great care when installing the batteries to observe correct
polarity. Always check the meter for operation immediately
after installing new batteries.
e
leCtromagNetiC
C
ompatibility
(emC)
This product has been tested for compliance with the
following generic standards:
EN 50081-1, EN 50082-1 and is certified to be
compliant.
The European Council Directive 89/336/EEC requires that electronic equipment does not generate elec-
tromagnetic disturbances that exceed defined levels and has an adequate level of immunity to enable it to be
operated as intended.
Since there are many electrical products in use that pre-date this Directive and may emit electromagnetic
radiation in excess of the standards defined in the Directive there may be occasions where it would be appro-
priate to check the analyzer prior to use. The following procedure should be adopted.
• Go through the normal start up sequence in the location where the equipment is to be used
• Switch on all localized electrical equipment that might be capable of causing interference
• Check that all readings are as expected (a level of disturbance in the readings is acceptable)
• If not, adjust the position of the instrument to minimize interference or switch off,
if possible, the offending equipment for the duration of the test
At the time of writing this manual (August 2011), UEi is not aware of any field based situation where such
interference has ever occurred and this advice is only given to satisfy the requirements of the Directive.
Note: Follow battery directions
on back of housing
Battery Compartment
Cover
Back of
Instrument
