IPX/IPN Series
Installation Guide
01A.01
7
4. INSTALLATION
1)
Place the installation template (paper) that
is included in the package on the desired
installation surface.
2)
Drill three holes in correct positions based
on the template paper, and insert anchor
blocks into the holes.
3)
When placing the camera body to the
installation surface, match three alignment
holes with three anchor blocks.
4)
Tighten the surface anchor studs.
5)
Connect all the required cables to the
camera.
6)
Adjust the lens position. Detailed
information can be found in
4.2. Setting the
Lens Position
.
7)
Place the dome cover on the main body of
the camera. Dome cover has three alignment
holes that match camera body’s alignment
holes.
8)
Once properly placed, insert hex screws
into the three holes of the body and tighten
them up with hex wrench driver.
Caution
!
To prevent products from damaging, place the camera on stable and non-vibrat
ing surfaces. If the stability is in doubt, consult with safety personnel for reinfor
cements, and then proceed with the installation.
