8
12
11
MADE IN CHINA
FCC Note
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
●
Reorient or relocate the receiving a ntenna.
●
Increase the separation between the equipment and receiver.
●
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
WARNING: Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference. (2) This device must
accept any interference received, including interference that may cause undesired operation.
The equipment may generate or use radio frequency energy. Changes or modifications to
this equipment may cause harmful interference unless the modifications are expressly
approved in the instruction manual. Modifications not authorized by the manufacturer may
void user’s authority to operate this device.
FCC Notice:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition with out restriction.
FCC Radiation Exposure Statement
Important Notice
Our company's products are improving all the time, design and specifications are subject to change
without notice.
All the information in this manual has been carefully checked to ensure accuracy, if any printing
errors, our company reserve the final interpretation right.
Li-Po Battery Disposal & Recycling
Wasted Lithium-Polymer batteries must not be placed with
household trash. Please contact local environmental or
waste agency or the supplier of your model or your nearest
Li-Po battery recycling center.
The propeller is seriously deformed.
Replace the propeller.
Low battery.
Charge the drone battery.
Incorrect installation of propeller.
Install the propeller in accordance
with the user manual.
The main bearing is seriously deformed.
Replace the main bearing.
The drone is
under-powered
orcan not fly.
Improper Calibration.
Please refer to the Calibration.
The propeller is seriously deformed
Replace the propeller.
The gyroscope did not reset after a
serious crash.
Turn off the power and refer to the
calibrate the helicopter according to
the instructions.
Motor is damaged.
Replace the motor.
The main bearing is seriously deformed.
Replace the main bearing.
The drone
could not
hover and
tilts to one
side.
Low battery.
Recharge the drone battery.
The battery is expired or over
discharge protection.
Buy a new battery from local seller to
replace the battery or charge the
battery.
Poor contact
Connect and disconnect the battery.
Switch damage
Replace the receiver board.
The drone
indicator
light is off.
The propeller is seriously deformed.
Replace propeller.
Motor is damaged.
Replace the motor.
Atmospheric pressure is not stable.
Refer to “Altitude Hold Mode”
instruction.
Not experienced enough.
Practice and read the cellphone
controlling instruction carefully.
Can’t
altitude
hold
Hard to control
by cellphone.
Metal-Scout Model: U12S
Manufacture time:
Manufacture address: Guangfeng Industrial Zone, Guangyi Street, Chenghai District, Shantou City, Guangdong Province, China
Manufacturer company: SHANTOU CITY CHENGHAI UDIRC TOYS CO., LTD
