Configure the identifiers of each PZ-1000A desk (from 1 to 16).
Each PZ-1000A must have a different identifier on the bus.
Power switch in OFF
Hold the selector NOTICE GENERAL (ALL AREAS) is activated during the switch to start position.
The display shows "
". Release the button GENERAL NOTICE.
Operate SWITCHES STEERING (up / down) until the display shows the required ID number (example 2).
Validate the identifier by pressing GENERAL NOTICE.
Turn the switch off, and 5 seconds later, put another time in ON.
Whenever you set up the desk, the display shows quickly the identification number (in this case 0.2) and then putting the last
address previously selected.
And configure each console system with its corresponding identifier.
Process:
Ad
CONFIGURE THE IDENTIFIERS OF EACH PZ-1000A DESK
Example 3: Notice to zones 5, 15 and 20:
1.
2.
3.
4.
5.
6.
By SWITCHES STEERING select the number 1 (WZ-1000A no. 1 module) which belong to zone 5.
Activate by the ZONE SELECT button the zone 5. The corresponding LED driver is activated fixed.
By SWITCHES STEERING select the number 2 (WZ-1000A no. 2 module) that belong to areas 15 and 20.
By the ZONE SELECT button activate areas 5 and 10. The corresponding LED drivers are activated fixed. In areas 5, 15 and 20
the music is off (if it was enabled). In all other areas not selected, the music continues
CHIME OF NOTICE: Press the corresponding button (CHIME ON). The associated LED lights while the chime sounds in the
selected area.
NOTICE: By the button (MIC ON / OFF), turn the microphone. The pilot lights. Give the notice. At the end, turn the microphone
back on el pressing button (MIC ON / OFF). Defuse the SELECTOR AREA Number 5, 15 and 20 and in reverse order of
selection.
USE PZ-1000A DESK
TO GIVE NOTICE
Example 1: We want to give a notice to number 5.
1.
2.
3.
4.
By SWITCHES STEERING select the number 1 (WZ-1000A no. 1 module) which belong to zone 5.
By the ZONE SELECT button activate the zone 5. The corresponding LED driver is activated fixed. In zone 5 the music is off (if it
was enabled). In all other areas not selected, the music continues.
CHIME OF NOTICE: Press the corresponding button (CHIME ON). The associated LED lights the chime sounds in the selected
area.
NOTICE: By the button (MIC ON / OFF), turn on the microphone. The pilot lights. Give the notice. At the end, turn off the
microphone by pressing button (MIC ON / OFF). Defuse the ZONE SELECTOR number 5. The pilot zone 5 LED turns off.
Example 2: Notice to zones 1 to 10
Proceed as in the previous section, but by selecting the 10 ACTIVATION AREAS (TEN AREAS). The 10 areas are activated
simultaneously.
GENERAL NOTICE:
By selecting the GENERAL NOTICE (ALL AREAS) all areas of the system are activated at a time. At the end of the notice,
deselect the GENERAL NOTICE.
Note: Selecting and Deselecting NOTICE, erase all current selections possible.
PZ-1000A / WZ-1000A
9
5
610.490A
rev.
2
