(Cpu central card: 107.331A)
Configuration of the MX-100B Matrix
4.2. Configuration of the interface RS232C / RS485
4.3. Configuration of the temporization (programming keys)
If the computer does not have a series port RS422-RS485, then it will be necessary to enclose an external
modulus of conversion, between the series port RS232C of the PC and the MX-100B Matrix.
The following communication type must be chosen by the interface:
- Tx ON - Rx ON
- DCE
The keys located on the front panel of the Matrix permit to configure or test the MX-100B Matrix (8x8 only).
The jumper S16 makes possible to select two temporizations for avoiding the repetition of the key:
- S16 = OFF
350 ms
- S16 = ON
500 ms
J5
J3
J2
J1
J4
DAY / NIGHT
DEGRADE 1
PROG.
RS-422 / RS-485
J19
DIGITAL (16 x 16)
RS-232
S8
S11
S10
S12
S14
S17
S16
S15
S2 = OFF
S1 = ON
S28 = ON
S9 = ON
S4 = ON
S3 = ON
S23
S13
= ON
(1-2)
S27
= ON
(1-2)
1
3
2
2
3
1
Address RS485:
S14, S12, S10, S11
For a communication with the program
SF-101, the direction must be programmed 0.
(See the configuration table above).
-
Tempo, between keys:
S16=OFF
®
350 ms
S16=ON
®
500 ms
S21=ON
S20=ON
S26=ON
S18
S21
S25
S20
S24
S26
S18=OFF
S25=OFF
S24=OFF
S20 = ON :
Only the Matrix which is at the end
of the line must charge the line
RS485 (S20=0N).
If the computer is connected only to one Matrix
then (S20=0N).
(Permits to insert the charge resistance at the
end of the line).
If the distance between PC computer and matrix is more than 15 meters, it is necessary to use serial port RS422
in order to secure the system.
To choose RS232 or RS422 serial port on the MX-100B matrix refer to chapter 3-3 (configuration thanks to
software SF-101)
17
MX-100B