User Manual V2.4
Date: 2011.04.20
6
cannot discover this adaptor.
(Default)
Y
The adaptor enters the discoverable mode.
?
Inquire the current setting.
ECHO=
This command is used to specify whether the adaptor echoes
characters received from the UART back to the DTE/DCE.
N
Command characters received from the UART are not echoed back to
the DTE/DCE.
(Default)
Y
Command characters received from the UART are echoed back to the
DTE/DCE.
?
Inquire the current setting.
FLOW=
This command enable or disable flow control signals (CTS/RTS) of the
UART port. Note, the setting is not affected by DEFAULT.
The command will need 1 second delay.
(Default)
N
Disable flow control.
Y
Enable flow control.
?
Inquire the current setting
NAME=
This command is used to specify a name for the adaptor.
You can specify a friendly name using 0 to 9, A to Z, a to z, space and –,
which are all valid characters. Note that “first space or -, last space or –
isn’t permitted”. The default name is “Serial Adaptor”.
(Default)
Serial
Adaptor
Default device name
xx….xx
“xx….xx” is a character string with the length from 2 to 30.
R
Restore the default settings name=“Serial Adaptor”.
?
Inquire the name of the local adaptor.
PARITY=
This command is used to specify parity bit setting of COM port.
The command will need 200 ms delay.
(Default)
N
None parity bit
O
Odd parity
E
Even parity
?
Inquire the current setting.
PIN=
This command is used to specify a PIN. The default PIN is “1234”.
Paired adaptors should have a same PIN. This command is used to
specify a PIN. The default PIN is “1234” and the length is not smaller
than 4. Paired adaptors should have a same PIN. The PIN code
includes the numeral and English characters.
(Default)
1234
xx….xx
“xx….xx” is a
4~16 digit string or English character (in capital or lower
case)
N
Cancel authentication by PIN.
R
Restore the default settings PIN=“1234”.
?
Inquire the current PIN.
PROMPT=
The command is used to decide whether result messages are prompted
when Setup commands are executed. The result messages are:
OK/ERROR for command execution, or CONNECT/DISCONNECT/Try
Connect Device for connection status.
(Default)
Y
Prompt result messages.
N
Not prompt result messages.
?
Inquire the current setting.
