��
It is an error message generated
when the cut surface of optical fiber is
poor quality.
HOW TO
· Check the state of optical fiber cutter.
· Cut the optical fiber yet again.
WHEN THE SPLICE LOSS
IS TOO HIGH
HOW TO DEAL WITH THE SPLICING PROBLEMS
It may have been caused by dirt or dust
on the surface of fibers.
HOW TO
· Carefully clean the surface of the fibers.
· DO NOT clean the optical fiber after cutting to prevent
dust rom being gathered on optical fiber’s cross section.
· DO NOT push in the optical fiber when putting is on V-Groove.
Optical fiber should be placed from top to bottom V-Groove.
Bad electrodes
HOW TO
· Keep the V-groove clean at all times.
The arrangement of the fibers can be interrupted
by the dirtin the V�groove.
HOW TO
· Replace the electrodes.
The tips are bent or contaminated if they are worn out.
HOW TO
· Check the set values of arc discharge amount and
arc discharge time and reset them, if necessary.
· The machine is delivered after being set to the most
optimized values from the factory.
Improper arc discharge or arc discharge time.
HOW TO
· Check if the proper splice mode for the fiber
has been selected.
Inappropriate splice mode
