UCHIDA AeroDieCut, Operation Manual

Page: 46 / 48

AeroDieCut OPERATION MANUAL
45
⑤
The cutting position in the feed direction is not stable.
・
Adjust the positional deviation depending on the pressurization direction.
（
Page32
）
・
Set the pressurization direction to ONE WAY. （ Page32 ）
・
Make sure the paper is loaded correctly.
・
Make sure the Die board is set correctly.
（
Page24
）
⑥ Skewing cut
・
Make sure the print is not skewed against the paper.
・
Make sure the paper is set correctly.
・ Make sure the Die board is set correctly. （ Page24 ）
・
If the tilt is constant, adjust by the Skew adjusting dial. （ Page38 ）
・
If the tilt is not constant, the paper feed is not stable.
…
Shorten the PAPER FEED WORK TIME.
（
Page31
）
… Down to the Belt speed. （ Page30 ）
⑦
Cutting quality is not well.
・
Make sure that there is no paper, pieces of paper, paper dust, etc. remains inside the
machine.
・ Make sure the Die board and Cutting plate for pain.
・ Depressurize the level of pressurization. （ Page27 ）