UBTECH AIMBOT
USER MANUAL
UBTECH ROBOTICS CORP LTD
password, reset the password forgotten, and remote networking mode.
•
Log in to the home page to learn about the working status, life status, and component
status of the device.
•
Working status, display status, room, remaining time. The time and report link of the
last kill mission. The status includes idle, disinfection, disinfection pause, and failure.
•
Life status, showing the current usage and expected usage of the device's disk status
and lamp life.
•
The component status shows the main version number of the device, which is closely
related to the upgrade. Component version can see the sub-version numbers of
different modules, including business components and MCU components.
User login
User activate. Homepage
4.1.3 Task Management
The entire disinfection process includes arriving at the disinfection room, setting the
disinfection parameters, starting the disinfection, suspending/continuing the disinfection,
and ending the disinfection. At the same time, because there is no central server, there is
no way to watch real-time video.
•
The device can only perform one task at a time.
•
Kill on the spot: Start disinfection at the current position.
•
The policy setting is to set the disinfection parameters that should be used for a certain
disinfection point. As shown in the figure, configuring the disinfection point is divided
into two parts.
•
Elimination mode: There are two levels of "full power" UV lamps with full on
and "low power" with half UV lamps on.
•
"Time to kill": 3, 5, 10, 15, 30, 60 minutes.
•
The security settings are all turned on by default. Check "Access Control Card",
"PIR", and "Remote Control". The user cannot cancel.
•
Frequent switching affects the UV life, so the UV lamp will not be turned off while
moving.
