Ublox SARA-N2 Series, System Integration Manual

Page: 43 / 95

SARA-N2 / N3 series - System integration manual
UBX-17005143 - R13 Design-in Page 43 of 95
C1-Public
2.3.2 Module reset (RESET_N)
2.3.2.1 Guidelines for RESET_N circuit design
As described in SARA-N2 series data sheet [1] and SARA-N3 series data sheet [2] , the modules have
an internal pull-up resistor on the RESET_N input line, so an external pull-up is not required on the
application board.
When the RESET_N input is connected to a push button that shorts the RESET_N pin to ground, the
pin will be externally accessible on the application device. According to EMC/ESD requirements of the
application, provide an additional ESD protection (e.g. EPCOS CA05P4S14THSG varistor array) on the
line connected to this pin, close to accessible point, as described in
Figure 21 and Table 15 .
☞
ESD sensitivity rating of the RESET_N pin is 1 kV (Human Body Model according to JESD22-A114).
Higher protection level can be required if the line is externally accessible on the application board,
e.g. if an accessible push button is directly connected to
RESET_N pin. Higher protection level can
be achieved by mounting an ESD protection (e.g. EPCOS CA05P4S14THSG varistor array) close to
accessible point.
When the RESET_N input is connected to an external device (e.g. application processor), an open drain
output can be directly connected without any external pull-up, as described in Figure 21 and Table 15 .
The internal pull-up resistor provided by the module pulls the line to the high logic level when the
application processor does not force the
RESET_N pin low.
SARA-N2/N3
18 RESET_N
Reset
push button
ESD
Open
drain
output
Application
processor SARA-N2/N3
18
RESET_N
TP TP
Figure 21: RESET_N application circuits using a push button and an open drain output of an application processor
Reference Description Part number - Manufacturer
ESD Varistor for ESD protection B72590T8140S160 - TDK
Table 15: Example of ESD protection component for the RESET_N application circuit
☞
If the external reset function is not required by the customer application, the RESET_N input pin
can be left unconnected to external components, but it is recommended providing direct access
on the application board by means of accessible test point for diagnostic purpose.
2.3.2.2 Guidelines for RESET_N layout design
The reset circuit ( RESET_N ) requires careful layout due to the pin function: ensure that the voltage
level is well defined during operation and no transient noise is coupled on this line, otherwise the
module might detect a spurious reset request. It is recommended to keep the connection line to
RESET_N as short as possible.