SARA-G3 and SARA-U2 series - System Integration Manual
UBX-13000995 - R08
Objective Specification
Design-in
Page 97 of 188
2.3.1.2
Guidelines for PWR_ON layout design
The power-on circuit (
PWR_ON
) requires careful layout since it is the sensitive input available to switch on the
SARA-G3 and SARA-U2 series modules until a valid
VCC
supply is provided after that the module has been
switched off by the AT+CPWROFF command: ensure that the voltage level is well defined during operation and
no transient noise is coupled on this line, otherwise the module might detect a spurious power-on request.
2.3.2
Module reset (RESET_N)
2.3.2.1
Guidelines for RESET_N circuit design
As described in Figure 21, the module has an internal pull-up resistor on the reset input line: an external pull-up
is not required on the application board.
Connecting the
RESET_N
input to a push button that shorts the
RESET_N
pin to ground, the pin will be
externally accessible on the application device: according to EMC/ESD requirements of the application, provide
an additional ESD protection (e.g. EPCOS CA05P4S14THSG varistor array) on the line connected to this pin, close
to accessible point, as described in Figure 45 and Table 24.
ESD sensitivity rating of the
RESET_N
pin is 1 kV (Human Body Model according to JESD22-A114). Higher
protection level can be required if the line is externally accessible on the application board, e.g. if an
accessible push button is directly connected to
RESET_N
pin. Higher protection level can be achieved by
mounting an ESD protection (e.g. EPCOS CA05P4S14THSG varistor array) close to accessible point.
Connecting the
RESET_N
input to an external device (e.g. application processor), an open drain output can be
directly connected without any external pull-up, as described in Figure 45 and Table 24: the internal pull-up
resistor provided by the module pulls the line to the high logic level when the
RESET_N
pin is not forced low by
the application processor. A compatible push-pull output of an application processor can be used too.
SARA-G3 series
SARA-U2 series
18
RESET_N
Reset
push button
ESD
Open
Drain
Output
Application
Processor
SARA-G3 series
SARA-U2 series
18
RESET_N
TP
TP
Figure 45: RESET_N application circuits using a push button and an open drain output of an application processor
Reference
Description
Remarks
ESD
Varistor for ESD protection
CT0402S14AHSG - EPCOS
Table 24: Example of ESD protection component for the RESET_N application circuit
If the external reset function is not required by the customer application, the
RESET_N
input pin can be
left unconnected to external components, but it is recommended providing direct access on the
application board by means of accessible testpoint directly connected to the
RESET_N
pin.
