NORA-W36 series - System integration manual
UBX-22021120 - R01
Handling and soldering
Page 28 of 48
C1-Public
5
Handling and soldering
⚠
NORA-W36 series modules are Electrostatic Sensitive Devices that demand the
observance of special handling precautions against static damage. Failure to
observe these precautions can result in severe damage to the product.
5.1
ESD handling precautions
As the risk of electrostatic discharge in the RF transceivers and patch antennas of the module is of
particular concern, standard ESD safety practices are prerequisite. See also
Consider also:
•
When connecting test equipment or any other electronics to the module (as a standalone or PCB-
mounted device), the first point of contact must always be to local GND.
•
Before mounting an antenna patch, connect the device to ground.
•
When handling the RF pin, do
n’t
touch any charged capacitors. Be especially careful when handling
materials like patch antennas (~10 pF), coaxial cables (~50-80 pF/m), soldering irons, or any other
materials that can develop charges.
•
To prevent electrostatic discharge through the RF input, do
n’t
touch any exposed antenna area. If
there is any risk of the exposed antenna being touched in an unprotected ESD work area, be sure
to implement proper ESD protection measures in the design.
•
When soldering RF connectors and patch antennas to the RF pin on the receiver, be sure to use an
ESD-safe soldering iron (tip).
Figure 11: Standard workstation setup for safe handling of ESD-sensitive devices
5.2
Packaging, shipping, storage, and moisture preconditioning
For information pertaining to reels, tapes or trays, moisture sensitivity levels (MSL), shipment and
storage, as well as drying for preconditioning, refer to the NORA-W36 series data sheet
