NINA-B3 series - System integration manual
UBX-17056748 - R13
Regulatory information and requirements
Page 52 of 72
C1-Public
☞
When the device is so small or for such use that it is not practicable to place the statement above
on it, the information shall be placed in a prominent location in the instruction manual or pamphlet
supplied to the user or, alternatively, shall be placed on the container in which the device is
marketed.
In case, where the final product will be installed in locations where the end user is unable to see the
FCC ID and/or this statement, the FCC ID and the statement shall also be included in the end product
manual.
Canadian market
The host product shall be properly labelled to identify the modules within the host product.
The Innovation, Science and Economic Development Canada certification label of a module shall be
clearly visible at all times when installed in the host product; otherwise, the host product must be
labelled to display the Innovation, Science and Economic Development Canada certification number
for the module, preceded by the word “Contains” or similar wording expressing the same meaning, as
shown in
or
Le produit h
ôte devra être correctement étiqueté, de façon à permettre l’identification des modules
qui s’y trouvent.
L’étiquette d’homologation d’un module d’Innovation, Sciences et Développement économique
Canada devra être posée sur le produit hôte à un endroit bie
n en vue, en tout temps. En l’absence
d’étiquette, le produit hôte doit porter une étiquette sur laquelle figure le numéro d’homologation du
module d’Innovation, Sciences et Développement économique Canada, précédé du mot « contient »,
ou d’une formulation
similaire allant dans le même sens et qui va comme suit:
This device contains
FCC ID: XPYNINAB30
IC: 8595A-NINAB30
Figure 18: Example of an end product label that includes a NINA-B30 series module
This device contains
FCC ID: XPYNINAB31
IC: 8595A-NINAB31
Figure 19: Example of an end product label that includes a NINA-B31 series module
5.2.8
End product user manual requirements
US market
labelling requirements, the following statement shall be placed in a
prominent section of the instruction manual, when it cannot feasibly be placed on the physical device:
“This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including interference that may cause
undesired operation.”
The statement “this device contains” along with the FCC ID of NINA
-B30 or NINA-B31, as shown in
shall also be placed in the instruction manual when it cannot be placed on the
physical device.
